When we took off our heavy winter clothes and started to be busy for the new year, we looked at our own home that was sleeping in a lazy winter. Do you want to let your old family show off your face with your own hands? Here, Xiao Bian specially integrates the most "brilliant" home information of this spring, so that you can easily put a beautiful "Spring" on your home!      (1) The floor should be laid in the later stage of construction and should not be cross-constructed. It should be sanded and painted as soon as possible after laying. So as not to soil the floor or deform the moisture.      (2) Before laying the floor, it is advisable to unpack and stack it on the paving site for 1-2 days to adapt it to the environment, so as to avoid expansion and contraction after laying.      (3) The paving should be well protected against moisture, especially in the case of wet conditions such as the bottom layer. Moisture-proof measures include applying moisture-proof paint, paving moisture-proof film, using padding treasure, and so on.      (4) The keel should be flat and firm, and should not be reinforced with cement. It is best to use expansion bolts and US nails.      (5) The keel should be made of larch and Liuan with strong nail holding power. The moisture content of the keel or wool floor should be close to the moisture content of the floor. The keel spacing should not be too large, generally not more than 30 cm. The ends of the floor should be placed on the keel, and should not be left empty, and nails must be nailed on each keel. Do not use water based glue.      (6) The floor should not be laid too tightly. There should be enough expansion joints (0.5~1.2 cm) around it, and it should not be over-widely laid. If it is wider, it should be separated and cut, and then the copper strips should be transitioned.      (7) Floors and halls, toilets, kitchen rooms, etc. should be thoroughly isolated and protected from moisture.      (8) The chromatic aberration of the floor is inevitable. If there is a high requirement for chromatic aberration, it can be pre-sorted and adopt a gradual transition method to reduce the visual abrupt change.      (9) Avoid flushing with water during use, avoid long-term sun exposure, continuous air blow of air conditioner, prevent rain forest at the window, and avoid hard objects from rubbing. To protect the floor, wax can be applied to the painted surface (from the perspective of protecting the floor, waxing is better than painting).      Bamboo floor maintenance:      Proper use and maintenance is the key to extending the service life of bamboo flooring. In recent years, some users have complained about the use of bamboo flooring, causing some quality problems. In this case, it is necessary for dealers or enterprises to do a good job. At the same time, it is also necessary to promote the use and maintenance knowledge to consumers.      Bamboo flooring should pay attention to the following points in use:      1, maintain indoor dry humidity      Although the bamboo floor is dried, it reduces the dimensional change. However, because the bamboo material is a natural material, it will also be deformed as the climate changes.      In the dry season in the northern region, especially when heating, the indoor temperature can be adjusted by different methods such as using a humidifier or a heater to put water; in the southern area, the window is ventilated and kept indoors.      To this end, indoors should try to avoid sun exposure and rain, if it is water, it should be dried in time.      2, to avoid damage to the floor surface of the bamboo floor paint, should avoid hard objects, sharp scratches, metal friction and so on.      3, the correct cleaning of the floor in the daily use process, keep the ground clean, clean, use a clean broom to sweep, and then use the wringed mop to take a new look. If the conditions permit, it is better to have a floor wax once every two to three months.      Cork floor maintenance      The maintenance of cork flooring is simpler than other wooden flooring. During use, sand should be prevented from being brought into the room, and individual sand particles should be brought in without affecting the wear. Therefore, when the sand is brought in, pressed into the foot and pressed into the elastic layer. When the footsteps leave, it will pop up again. Of course, it should be reminded here that it is not advisable to bring in too much sand, which will cause flow wear. Therefore, although it is affected by the sand, it will wear too much. Therefore, the sand that is brought into the room should be removed in time. Vacuum cleaners do not have to worry about warping and mildew.      If it is used in a place with large passenger flow, if there is wear and tear in some places after three or five years, it can be partially compensated, that is, the coating is re-applied at the local part. The method is very simple. Use sandpaper to polish it at the worn place and remove it. The dirt on the surface is then wiped clean with a dry soft cloth, repainted, or partially covered with a polyester film.      Cleaning and maintenance of composite wood flooring      In general, you can use a vacuum cleaner or broom to clean the surface dust, then damp it and wring it out to a non-drip rag or mop to wipe the floor surface. After mopping the floor, it is best to open the doors and windows to allow air to circulate, or use a fan to blow the floor as soon as possible. In addition, it is necessary to avoid damage to the wear-resistant layer of the composite wood floor, otherwise the moisture-proof function and brightness of the floor will be affected. When walking on the floor, try to wear cloth slippers, and put a soft bottom protection pad on the feet of the furniture to avoid the "foot" of the furniture scratching the wear-resistant layer of the floor. Do not let the heavy items smash the wear layer. Do not use sandpaper, sanders, steel brushes, strong decontamination powder or metal tools to clean laminate flooring. If you have cats in your home, you have to find a way to solve the damage of cat claws. It is not recommended to wax.      pay attention:      1. Never use water to wash the floor;      2, can not use a very corrosive detergent to clean the floor, the wear layer is aluminum oxide, it is an amphoteric oxide, can react with acid, but also react with alkali.      3, to avoid alkaline substances, scrub with rice water is a good way.      4. Avoid sanding, waxing or painting on the floor. Mesh fence, also known as wire mesh fence. It is a popular choice for both residential and commercial properties due to its durability, affordability, and low maintenance. Wire Mesh Fencing,Mesh Rolled Fencing,Mesh Wire Fence ,Roll Mesh Wire Fence HEBEI DOUDOU METAL FENCE PRODUCTS CO.,LTD. , https://www.ddfencefencing.com
Mesh fences are commonly used for security purposes, as they provide a high level of protection against intruders and animals. They are also used for sports fields, parks, and playgrounds to keep people and animals in or out of a designated area.
Mesh fences come in different heights, gauges, and colors to fit various applications and preferences. They are easy to install and can be customized to fit irregular shapes and slopes.
While mesh fences are not completely impenetrable, they are an effective deterrent against unwanted entry and can be enhanced with additional security features such as barbed wire or privacy slats.
Â