The door is a safety nurse in our home, but even the most powerful "nurse" has a "sick" day. For the wooden doors in the home, it is generally not replaced because of a small problem, but at the same time, it is not possible to sit on these small diseases and affect the appearance, so the method often used is to renovate the wooden doors. Part1: Different treatment of wooden door repair options in different situations Wood wooden doors are mostly used as interior doors, and their appearance has a great influence on the overall home effect. For the renovation of wooden doors, different solutions need to be taken for different damage situations. First, the wooden facade layer is damaged If the wooden door is only a slight damage such as scratches on the surface layer, stains that are difficult to erase, etc., then direct paint coverage can be considered. Method steps: The finished door is generally waxed. First, the wooden door is sanded with sandpaper to improve the adhesion of the paint, and then the primer and the top coat are directly applied. Second, the wooden door base is damaged If the wooden door base is damaged, such as a crack or pothole in a piece. Then the method of treatment is slightly more complicated than the damage of the surface layer. That is, before the paint is covered, the putty needs to be filled with the putty and filled. Then sand the paper and apply the primer and topcoat. Part2: Renovation materials Do not care about wooden door renovation paint selection In addition to different damages, take a slightly different approach. One problem that needs to be noticed when renovating wooden doors is the choice of refurbished paint. Paint has a great influence on the quality and environmental protection of wooden door renovation. When choosing, you can't be careless. First, refurbished paint is best to choose the same paint When the wooden door is refurbished, it is best to choose the same type of paint as the original paint of the wooden door. Generally speaking, the adhesion of the same paint will be relatively good. If oil paint is used, it is best to use oil paint now. But it is not so absolute. When refurbishing, the use of different types of paint will not have a significant impact on the quality of the wooden door. Second, oil paint selection In general, there are three types of oil paints, polyester paint, nitrocellulose paint and alkyd paint. Alkyd paint is an early product, it is slow to dry and is used less and less in decoration; nitro paint dries quickly but the paint film is thin, it needs to be brushed many times, and the humidity is easy to whiten; polyester paint It is used more often, and the film formation is fast and the effect is better. Third, water-based paint selection Waterborne paints are paints that use water as a diluent. Waterborne wood lacquer is the most technically challenging and technologically advanced product in wood coatings. It has the advantages of non-toxic, environmentally friendly, odorless, volatile, non-flammable, non-flammable, non-yellowing, and large brushing area. The renovation of wooden doors is mostly carried out indoors. The oily paint has a large smell and is difficult to volatilize. It is recommended that everyone use water-based paint to renovate. Fourth, paint color selection When the wooden door is refurbished, the paint color can be chosen at will. However, it should be noted that if the original oil is used and the color is dark, it cannot be covered with a light paint unless the original color is covered with a darker color. If it is originally mixed, there is no limit on the color, and you can change it to any color. Part3: There are ways to look at the renovation of wooden doors. It should be noted that if the wooden door is refurbished, the longer it takes to paint the first paint, the better. Because the original substrate has been dried out during renovation, it will not affect the results of repainting. First, select matching products when deploying When wood lacquer is applied, if it is a water-based wood lacquer, it only needs to be diluted with water. If you choose nitrocellulose lacquer and polyurethane lacquer, you need to add relevant curing agent and diluent. It must be formulated in strict proportion. Therefore, it is best to have professional guidance during the construction of nitrocellulose lacquer and polyurethane lacquer. Strictly proportional and use matching thinners and curing agents to avoid problems such as biting the bottom and wrinkling. Second, use fine sandpaper to polish When constructing, you should not use coarse sandpaper for the sake of the map, but use fine sandpaper. The polishing is more delicate and the adhesion of the paint film is better. Third, need to set aside drying time In general, the paint brush can be applied three times with the primer, but each time it takes 4-6 hours to brush the second coat. The worker brushes the paint a second time every 1-2 hours for the figure. The film did not dry out, affecting the final effect. Fourth, it is best to take the wooden door down for construction The wooden door renovation is mostly carried out indoors. It is better to remove the door and put it in a special room for better spraying. There is no dust to reduce environmental pollution; secondly, the front and back of the door can be seen very clearly. If it is sprayed directly on the door, it will easily generate fog when spraying, which will affect the line of sight and affect the spraying effect. Five, the remaining paint difference treatment After the waterborne wood lacquer is used, the remaining lacquer can be stored in a cool place and kept for future use. Nitrocellulose lacquers and polyurethane lacquers can only be used in one-time use due to the addition of curing agents and thinners, and can only be disposed of for the remaining coatings. At the same time, after the construction is completed, the discarded paint should be properly disposed of, and the tools should be cleaned in time. The Blush brush is a makeup tool used to apply blush in makeup. There are many styles, choosing the right blush brush can make facial makeup more delicate.
Blush Brush Always Used Cream Blush Brush,Powder Blush Brush,Ultra Plush Blush Makeup Brush,Blush Brush Tapered etc.
Cream Blush Brush,Powder Blush Brush,Ultra Plush Blush Makeup Brush,Blush Brush Tapered Jilin Xiangqi Technology Co., Ltd , https://www.xqccosmetics.com
A good blusher also needs an easy-to-use blush brush to achieve the maximum polishing effect.
The brush basically consists of three parts: a brush handle, a metal joint handle and bristles.
The brush handle is divided into a long handle and a short handle. The length of the handle can be selected according to the different makeup habits of each person. Soak in water for a long time to avoid shortening the service life of the brush;
The bristles are the most important part of the brush, which can be divided into natural animal hair and synthetic hair: animal hair is very soft and feels comfortable to use; while synthetic hair is harder, but has better elasticity.
It is necessary to choose the appropriate bristle material according to the different functions of the brush. The blush brush needs to be thick and light. The animal hair brush is the most suitable. The bristles should be large, soft and well-made.