Shanghai Xinzhuang Instrument Co., Ltd. Xinzhuang (LNB) brand biochemical incubator has two-way temperature regulation system for refrigeration and heating, temperature controllable function, and is the research of biology, genetic engineering, medicine, health and epidemic prevention, environmental protection, agriculture, forestry and animal husbandry. The important test equipment of institutions, universities, production units or departmental laboratories is widely used in low temperature constant temperature test, culture test and environmental test. The biochemical incubator controller circuit consists of a temperature sensor, a voltage comparator, and a control execution circuit. The circuit principle of Shanghai Xinzhuang Instrument Biochemical Incubator: The temperature sensor circuit uses a new temperature sensor integrated circuit IC1. The voltage comparator circuit is composed of resistors R1-R7, temperature setting potentiometers RP1, R-tooth and voltage comparator integrated circuits IC2 (N1, N2). The control execution circuit is composed of transistors V1, V2, relays K1, K2, and diodes VD1, VD2, and the like. The biochemical incubator can be restructured with an old single or double door refrigerator: use the function of the refrigerator itself to cool, install heating devices (such as electric heating wire or 150W iodine tungsten lamp) and exhaust fan under the inside of the refrigerator (can make the temperature inside the box) Evenly). Potentiometer RPl is used to set the upper limit of temperature, and RP2 is used to set the lower limit of temperature. The relay K1 controls the heating device by heating the intermediate relay (shown in the circuit), and the relay KZ controls the refrigeration system of the refrigerator through the refrigeration intermediate relay (drawn at the end of the circuit). Pins 5 and 2 of IC2 are connected to the center plugs of RP1 and RP2 respectively. Pins 6 and 3 of IC2 are connected to the output of ICI through resistor R3. When the voltage value of pin 2 of IC2 minus the voltage value of pin 5 is approximately equal to 0·OlV, the corresponding temperature is 1 °C. When the temperature in the biochemical incubator is within the set temperature range, the voltage at pin 2 of IC2 is higher than the voltage at pin 5, and the voltage at pin 3 and pin 6 is equal to the voltage at pin 2 (or lower than pin voltage at 2 feet). Voltage), 1 pin and 7 pin output low level, VI and V2 are cut off, relay Kl, K2 are not sucked, cooling and heating circuits are not working. When the temperature inside the box exceeds the upper limit of the set temperature, the voltage of pin 3 and pin 6 of IC2 will be higher than the voltage of pin 2 and pin 5, and pin 1 of IC2 changes from low level to high level, so that V2 is turned on. The relay K2 is pulled in, its normally open contact is closed, and the refrigeration system works. When the temperature inside the box is lower than the lower limit of the set temperature, the voltage of pin 3 and pin 6 of IC2 is lower than the voltage of pin 2 and pin 5, and the pin 7 of IC2 changes from low level to high level, then Vl is turned on. The relay K1 is pulled in, its normally open contact is turned on, and the heating circuit works. The components and parts choose Rl-R5 to select 1/4W metal membrane resistor, the accuracy should be 1%; R6-R9 can choose 1/4W carbon membrane resistor. Both RPl and RP2 use a wire wound potentiometer with higher precision. C uses monolithic capacitors. Both VDl and VD2 use the 1N4148 silicon switching diode. Vl and V2 select S9013 or C8050 type silicon NPN transistor. ICl selects LM35DZ or LM36, TMP36 type temperature sensor integrated circuit; IC2 selects LM393 operational amplifier integrated circuit. Both Kl and K2 use a DC relay of l2V. Shanghai Xinzhuang Instrument Co., Ltd. specializes in the production of biochemical incubators, chilled water bath oscillators, anaerobic incubators, incubators, water baths and other series of more than 100 products widely used in environmental testing, health and epidemic prevention, medical, biochemical, Chemical and colleges and other scientific research institutions, welcome to consult and buy!
Makeup Tools help people make more beauty.
Henan Daxin Cosmetic Products Co., Ltd. is a manufacturer of cosmetic brushes that integrates product development, production and sales. The company mainly produces various types of makeup brushes, makeup brushes set, makeup sponges, makeup powder puffs and other products. We have a professional team, rigorous management, and strive to build a well-known brand of Chinese makeup brushes.
Makeup Tools Makeup Tools,Cosmetic Tools,Makeup Parts Tools,Makeup Accessories Tools Henan Daxin Cosmetics Co., Ltd. , https://www.dx-cosmetics.com