Paper drop refers to the phenomenon that paper falls under the machine during the process of entering the paper to the delivery table. Paper failure will result in more waste and delay in production. (1) The paper is uneven and wavy. Paper is not flat, making paper feeding difficult. Especially the whiteboard paper, it is easy to produce the front gauge paper is not in place, so that the paper pick-up paper is too small, and even the paper can not hold, so that the paper pick-up row and the transfer paper row can not be properly transferred and the paper is dropped. (2) The paper paper corner is upturned. When the paper goes to the previous position, the height of the tooth is lower than the height of the paper corner when the paper is raised, so that the paper can not be completely covered, even in the tooth decay. When the moment of closing touches the corner of the paper, the paper is ejected back, causing too little paper to fall off the paper. (3) Double sheets appear in the paper feed. When there is a double failure in the paper feed, the overlapped two sheets will appear a slightly faster, slightly slower condition. When entering the front gauge, the slow one may not be completely caught by the cavities and fall under the machine. (4) Paper feeding is not normal. Due to improper adjustment of the machine, the paper is skewed, too fast or too slow, causing the paper to be unstable and the paper is lost. (5) The distance of the previous specified position is incorrect. After the paper arrives at the pre-position, the gripper picks up the paper 4 to 6 mm. Too much is easy to tear the paper. Too little paper is lost due to insufficient paper. (6) The timing of contact between the paper take-up row and the impression cylinder is incorrect. If the paper pick-up paper is too early, it will break the paper; if it is too late, it will drop the paper because it can't hold the paper. (7) The force of the paper picking row is not enough. When the paper is discharged from the paper to half of the paper or only half of the individual rows of paper are caught, the force is too light and the paper should be re-adjusted. (8) Positioning and paper feeding time are not correct. When the paper arrives at the front gauge, the paper feed position is disordered due to the inconsistency between the speed of the paper and the connection time of the connection, and the paper is not good and the paper is dropped. Article source address: http:// Diversification of working postures is very important to your health. Sitting and standing alternate posture office work is becoming more and more popular, and height adjuatble table has also become very popular. Adjustable Computer Desk,Office Standing Adjustable Desk,Adjustable Height Workbench,Adjustable Height Office Standing Desks CHEX Electric Standing Desk , https://www.chexdesk.com
The ergonomic desk makes you no longer sit in the same position for several hours. This diverse office posture can also increase creativity, energy, concentration, and even increase calorie burn.
The Electric Standing Desk has a control panel with 4 memory keys allowing users to save the settings of 4 preset heights