The salt spray test chamber is used in a very wide range, but the operation is not as simple as imagined. The process of adding water is difficult to replace many newcomers who have just contacted the salt spray test chamber. The following is a detailed description by Lin Pinxiao. Introduce it.

1. The salt water tank, as the name implies, only needs to add salt water, but the salt water ratio must be 1:19. It is prepared according to 500g industrial salt and 9500g pure water. It can be added to the salt water tank by three-quarters. Generally available 2~3.

2, the saturated air bucket must be added pure water, the water valve should be opened before adding water, and then close after the water is added, leaving one-fifth of the water level.

3, the inside of the studio is also added pure water, the role of adding water is generally to prevent the box from causing dry aging phenomenon when the box is heated, the water level is slightly lower than the mist hole in the middle of the box, it will be more It's okay, the water will automatically drain from the drain behind the box.

4. When the sealing tank is working, just add an appropriate amount of pure water to the sealed water tank, which can effectively prevent the salt spray from overflowing. It is not much to add. When closing the lid, of course, the water and salt spray are not overflowing. of.

In the process of adding water to the salt spray test chamber, except for the brine tank, which is added with brine, the other is pure water. If you add the wrong one, it may cause the test to not work properly.

Lin frequency solves the problem of adding water to the salt spray test chamber for you.

Drawing Board

Flourescent Drawing Board

Guangdong Jishengke Industrial Co.,Ltd , https://www.jskpads.com