The money tree is a kind of foliage plant that everyone is familiar with. Because it is very nice outside, the ornamental value of the money tree is very high, and it is loved by many people. The origin of the money tree is in Africa. However, if you have a potted money tree in your home, be careful not to get your juice, because it may cause an allergic reaction! Let's take a look at the breeding method of the money tree. Heterosis of the money tree In April, when the outdoor temperature reached 18 °C or above, the large money tree plants were removed from the pot, and most of the perennial soil was shaken off. The joints of the tubers were weakened, and sulfur powder or ash was applied to the wounds. Planted in the pot. Be careful not to bury too deep when planting, and the top of the tuber can be buried 1.5 to 2 cm below the soil. In addition, according to the characteristics of latent buds on the tubers of the money tree, the large single tuber can be cut into small pieces with 2 to 3 latent buds. After the wounds are dried, they are first planted in a little. In the moist fine sand, the small tubers to be cut grow into independent plants and then planted in pots. Cutting propagation of money tree The cuttings can be provided with a single small blade, a segment of the leaf axis with 2 blades or a single segment of the leaf axis. From the point of view of rooting effect, the rooting rate of cuttings with leaf-leaf leaves is fast, the germination rate is high, and it is easier to open larger tubers. A single blade is inserted into a mixed substrate of river sand and vermiculite. After 10 to 14 days, a small spherical stem can be formed at the base of the leaf. After 2 to 3 months of cultivation, the plant can grow into a small plant. However, under normal circumstances, the seedling rate is not high. If the leaf shaft or the leaf axis is used as the cuttings for cutting, the substrate can be used as general fine sand, or it can be mixed with peat soil, perlite and river sand in a ratio of 3:1:1 to form a matrix. The depth of cutting into the soil is the ear. 1/3 to 1/2 of the length, leaving only the leaves outside the substrate, sprayed through the water and placed in the shade, maintaining the ambient temperature of 25 ° C ~ 27 ° C, depending on the dry and wet degree of the substrate, spray the leaf surface 1 ~ 2 times, to maintain the substrate slightly moist state, must not be excessively wet, otherwise it will cause the cuttings to rot, resulting in failure of cutting. When the cuttings form a certain root system, the middle part of the roots gradually expands to form spherical small tubers, and the tuber gradually enlarges. Some of the younger cuttings are washed with leaves due to high temperature or poor water management, but the tuber can survive, but the old leaves and The stem with the total petiole can also maintain green and vitality. A small amount of tubers can bud and grow new leaves in the same year, but the growth is weak and the growth is slow. The next year, the tubers will grow strong sprouts and grow normally. China Presentation Display Book, PVC Display Books manufacturer, choose the high quality leather PVC Display Book, Pvc Presentation Book, etc. Presentation Book,PVC Display Book,leather PVC Display Book MIFIA INDUSTRIAL CO., LTD., , https://www.stationery-manufacturer.com