Improve the PS version of the printing rate of 7 steps, the steps are in no particular order:

Step 1, when the number of prints is large, properly bake the plates. When baking, the temperature is generally 270 ° C, if the number of printed products is relatively small, the baking time is generally controlled at 70 seconds. When the number of printed products is large, the baking time should be controlled for 150 seconds.

In the second step, under the premise of ensuring the quality, the pressure between the printing plate and the blanket, the water roller and the ink roller should be adjusted to avoid the mutual force and wear the layout.

In the third step, the pressure of the water and the ink roller is generally controlled at about 5 mm on the printing plate.

In the fourth step and the last edition, the printing plate must be tightened to prevent the water from dissolving the paper and adversely affecting the printing plate.

In step 5, use the minimum amount of water on the principle that the plate is not dirty.

Step 6, correctly grasp the PH value of the water bucket solution, generally should be kept in the range of 5-6, if it is acidic.

Step 7 If the machine is to be suspended during the printing process, the printing plate should be glued according to the length of the downtime to prevent the plate from oxidizing.

Article source address: http://

Baking Tools

For novice bakers, choosing the right baking tools is the first lesson on the road to baking. In the end, which tools must be bought, which tools chicken useless? We have prepared the necessary tools for novice bakers.

Baking Tool,Silicone Mesh Steam Mat,Kids Silicone Baking Set,Egg Tart Mold

vchomy , https://www.vichenivchomy.com