How to quickly install the power supply of rubber high and low temperature test chamber?

How to quickly install the power supply of rubber high and low temperature test chamber? In order to ensure the normal operation of the equipment, the correct installation of the power supply is essential, that is how we can quickly and correctly install it during the installation process. What other matters are we to pay attention to? Next, Haida Technology will address the following issues for everyone:

1. If the three-phase power supply, please pay attention to mutual protection, if the three-phase power supply has electricity but the machine does not move, the machine may be in reverse phase, the adjacent two power lines are exchanged on the line.

2. If the line is to be in the water pipe, it must be a metal pipe through the ground.

3. Do not install the grounding cable on the gas pipe. Be careful when installing it.

4. Check whether the equipment is in operation before power supply configuration, whether the power cord, equipment, and air circulation are damaged or not, and whether the inner box is clean.

5 , power cord configuration: black zero line, yellow and green color for the ground, other colors are FireWire .

6. The input power supply voltage fluctuation range must not exceed the allowable range. The grounding line must be good, otherwise it will affect the test performance.

7 , according to the size of the machine power to configure the appropriate safety device to prevent the failure can be safely cut off the power supply.

8. After the machine is positioned in the safe space and then routed, it is also determined that the current and voltage of the wiring and the device are the same, otherwise there will be electric shock.

9 , confirm the input power is disconnected and then re-wiring, to avoid electric shock .

10. If the equipment has a three-phase motor, check whether the steering is correct when connecting the power supply. The single-phase motor has been adjusted its steering at the factory, and determine whether the steering is correct or not at the time of replacement to avoid affecting the performance.

11. When the wiring is completed and the equipment and the power supply are determined to be in compliance, all the power box covers must be installed before the power is turned on. Otherwise, there is a risk of fire due to electric shock .

12. It is forbidden to dismantle the electric box, the electric box door, the body side board and some safety protection devices to work, which will make the equipment in a dangerous operating state.

13 , the main power switch on the console to do less frequent operations, shut down when you just turn off the temperature switch and the user power switch can be .

How to quickly install the power supply of rubber high and low temperature test chamber? To sum up the above points, we only need to pay attention to the installation when it is usually installed. The installation of the power supply is also a very simple matter, and it is also a precondition for the smooth testing of the equipment. More information about rubber cryogenic chambers is welcome to visit the website of Haida Instruments.